Set up Syncthing on this VM by following the exe.dev recipe at https://exe.dev/deploy/syncthing.md?via=terminal from top to bottom. The recipe's example VM name is my-syncthing. This VM's name is the output of `hostname`: use it wherever the recipe writes my-syncthing. Skip the step that creates the VM; you are on it. You are done when all of these are true. Check each one yourself: - Syncthing 2.x installed from its official apt repository, started at boot by systemd. - The web GUI on a private port behind exe.dev login, with a GUI password saved in ~/syncthing/gui-password. - New folders land in ~/Sync with staggered versioning (90 days) switched on. - The VM's device ID, ready to add on your other devices. - A copy of the device's identity and settings in ~/syncthing, for rebuilding the VM as the same device. Read the whole recipe, including the closed details. For initial setup, follow "Install by hand" first, skipping VM creation and SSH. The walkthrough at the top is for the owner afterwards. Work as exedev. Never overwrite an existing ~/.local/state/syncthing or ~/syncthing/gui-password. Don't add devices or folders, don't set up Tailscale, and don't run Restore or Update. Verify syncthing@exedev.service is enabled and active, /rest/noauth/health answers OK on localhost:8384, the GUI address is 0.0.0.0:8384, and the folder defaults (path ~/Sync, staggered versioning) are set. Do not reboot. Never paste the GUI password into the chat; say it's in ~/syncthing/gui-password. Finish by giving the owner the VM's device ID and pointing them to "Connect your first device". Finish with the URLs I should open.