Set up Sentry on this VM by following the exe.dev recipe at https://exe.dev/deploy/sentry.md?via=terminal from top to bottom. The recipe's example VM name is my-sentry. This VM's name is the output of `hostname`: use it wherever the recipe writes my-sentry. Skip the step that creates the VM; you are on it. This recipe needs a 100GB disk, and a new VM's may be smaller. Before you install anything, run `df -h /`. If its size is under 90G, stop and ask me to grow the disk, either with this link: https://exe.dev/suggest?command=resize%20my-sentry%20--disk%3D100GB or, on my computer, with `ssh exe.dev resize my-sentry --disk=100GB`. When I say it's done, run `sudo resize2fs "$(findmnt -no SOURCE /)"`, check `df -h /` again, and carry on. You are done when all of these are true. Check each one yourself: - Sentry 26.11.0, every feature of the self-hosted release, restarted after a reboot. - A private dashboard on port 9000 and an ingest-only address on the VM's main URL. - Sentry's email (alerts, invitations) delivered through exe.dev, with no SMTP account. - A nightly export of users, projects and settings, with the secret key beside it. Read the whole recipe, including closed details, and follow "Install by hand" first. The opening walkthrough is for the owner afterwards. Do not run the later Restore or Update instructions. Do "Check the size" before installing: if the VM has fewer than 4 vCPUs, under 15 GB of memory or under 95G of disk, stop and give the owner the resize link from that step, with this VM's name; continue when they say it's done. The installer takes 15 to 30 minutes; run it in tmux and wait for it. Work as exedev in ~/sentry. Do not create a Sentry user, projects or send test email: the owner does that. Leave sharing alone; the VM stays private. Verify docker.service is enabled, `docker compose ps` shows every service up, localhost:9000/auth/login/ answers 200, localhost:8000/ answers 200 with the ingest message, and localhost:8000/auth/login/ and localhost:8000/api/0/ return 404. Check the backup timer is enabled and the first export exists in ~/sentry-backups. Finish with the dashboard URL on port 9000 and the createuser command from "Create your account" for the owner to run. Finish with the URLs I should open.