Set up Orca on this VM by following the exe.dev recipe at https://exe.dev/deploy/orca.md from top to bottom.

The recipe's example VM name is my-orca. This VM's name is the output of `hostname`: use it wherever the recipe writes my-orca. Skip the step that creates the VM; you are on it.

You are done when all of these are true. Check each one yourself:
- Claude Code and Codex on the VM using exe.dev's LLM integration, with no API key to paste
- Git set up, with a project at `~/project` for Orca's worktrees
- The VM ready to add in Orca as an SSH target; Orca installs its own server on first connect

Run the VM-side commands in "Set up the VM" only; skip creating the VM.
If `exeuntu configure` reports an existing user config, leave it alone.
For `git config`, use the owner's name and email if you know them, and
skip those two lines if you don't. If `~/project` already exists, leave
it alone. Verify with the checks at the end of that section: both print
`OK`. Skip the later sections and the FAQ. Finish by telling the owner to
add `<this VM's name>.exe.xyz` with user `exedev` in Orca under
Settings → SSH ("Connect Orca"), and that `/home/exedev/project` is the
project to add.

Finish with the URLs I should open.